The NFPA 7.10.1.9 States "The bottom of new egress markings shall be located at a vertical distance of not more than 6 ft 8 in. (2030 mm) above the top edge of the egress opening intended for designation by that marking. Egress markings shall be located at a horizontal distance of not more than the required width of the egress opening, as measured from the edge of the egress opening intended for designation by that marking to the nearest edge of the marking."
- Types of emergency lighting,LED modules built into luminaires for lighting
0 review2021-11-18
Are there “Battery-Powered” Exit Signs?
There is no such thing as a “Battery-Powered” Exit Sign that meets the codes set out in NFPA 101. Battery Backup Exit
0 review2021-11-180
Can I wire an Exit Light to a cord
Can I wire an Exit Light to a cord and plug so that it can be plugged into a wall outlet?Modification of any exit or eme
0 review2021-10-090
Swimming Pool Lights FAQs
How do I start gathering pool lighting ideas?You can find inspiration almost anywhere: our gallery of swimming pool
0 review2021-10-071
Do I need Emergency Lighting?
The law requires adequate and reliable illumination for all exits and paths of egress. A number of established codes fro
0 review2020-11-230
How long does an Emergency Light stay on for?
When the electricity goes out and the Emergency Mode begins, the light must illuminate at a minimum of 1 footcandle aver
0 review2020-11-140
What is the difference between damp and wet location?
A damp location is an exterior or interior location that is normally or periodically exposed to condensation of moisture
0 review2020-11-110
How often should I test my Emergency Lighting sytem?
You are required by law to test your exit and emergency lighting regularly. According to NFPA 101 Life Safety Codes, uni
0 review2020-11-090
What color Exit Sign do I need?
In the United States, Exit Signs can have either red or green lettering, but in most cases red is the safer bet. Many st
0 review2020-11-090
How do I test Exit Lights?
For non self-testing units, look for a small Push to Test button that cuts power to the unit, sending it into emergency
0 review2020-11-090